Replacement Airbags For your Vehicle

Airbag Light On | Reset Your Airbag light

How to reset and repair your airbag light.

Archive for October, 2012

Oct
31

Removing The Gold Ball From An Airbag Sensor

Posted by admin

How to salvage a gold plated marble from an airbag sensor module. This was done on a Ford Taurus part, but the procedure is similar for most cars and trucks.

Duration : 0:7:37

Read the rest of this entry »

Oct
31

How to turn off the airbag light in a aerio

Posted by admin

Done at night after in a rush to help another forum member. I AM NOT RESPONSIBLE FOR ANY DAMAGE YOU DO TO YOURSELF OR A CAR IN RELATIONSHIP TO THIS VIDEO TRY AT YOUR OWN RISK.

Duration : 0:4:45

Read the rest of this entry »

Oct
29

How do you reset a SRS light on 2000 Honda Accord, Besides taking to dealer?

Posted by admin

Seems to be common problem with Hondas, Has anyone had dealer to reset for them and what was cost?

Got that right, I know everyone fears the dreaded dealer but the air bag is an explosive ready to go off. I have 2 of my guys trained in proper maintenance and I am not a dealer I have a 35 year old shop and we do airbag and ABS service just like the big boys do. You need to get it in as it can false trigger but this light usually disables the bags.

Oct
28

Im thinking about buying a car but the airbag light is on?

Posted by admin

I’m thinking about buying a car that has an airbag light that’s on. What could I be getting myself into? Thanks!

Mostly when an airbag light comes on it is just due to a poor wiring connection. It happens very commonly in cars with an airbag built into the side of a seat backrest and as often as not then it is due to a poor connection where the wiring attached to the airbag mechanism is connected to the sub-loom where they connect under the seat base.

Oct
27

Honda civic ej9 1997 tornado SRS airbag light remover kit i

Posted by admin

I bought a eBay SRS light remover kit, and discovered myself how to fit it correctly, you need to cut the two wires for the airbag that come up the steering column, place the two prongs of the resistor/fuse or what ever you want to call it, into the wires, then solder together followed by shrink wrap or electric tape, any of the following should be fine on its own. Following this, I did the reset procedure of pulling a small yellow clip out of a board under the dash board, there are two yellow plugs, a big blue plug and green plugs, pull the smaller yellow plug out, place a paper clip in it, turn the ignition on, wait for the SRS light to go and pull the clip out. The light will then come back and reinsert the paper clip. As before the light will go and you will need to remove the paper clip. The SRS light will flash twice. On the second flash. Turn the ignition off, then back on and start the car as normally. The light will stay for a few seconds then disappear. When you next start the car, the SRS light will flash up with the rest of the lights as normal. The rest will turn of then 2-3 seconds later so does the SRS light. I hope this helped anyone who like myself was liking for an install vid for one of these kits

Duration : 0:0:35

Read the rest of this entry »

Oct
27

How to reset the MAINT REQD light on a Toyota Tacoma after maintenance

Posted by admin

When you see a yellow light called MAINT REQD in your 2005 — 2011 Toyota Tacoma, it means it’s time for an oil change (given it was reset after the last oil change). Check out this video, and see how you can turn off the MAINT REQD light after maintenance is complete. NOTE: This is not a check engine light. You can keep driving the truck even if the light is on. See more about the Toyota Tacoma at: http://www.sprinter-rentals.com/category/4×4-trailer/

Duration : 0:1:20

Read the rest of this entry »

Oct
25

Reset the service light on a smart.

Posted by admin

A simple guide to show you how to reset the service indicator on a smart.

This method works on all smarts but the button placement will change.
The smart in the video is a fortwo 451.
If you can’t get it to work, you aren’t doing it right.

Ignition on,
double tap the button to bring up the service countdown,
ignition off,
press and hold the button,
ignition on,
keep the button held down until the service indicator resets. This can take up to 10 seconds.

Duration : 0:0:32

Read the rest of this entry »

Oct
23

How to Reset Maintenance/Oil Light on 2009-2011 Honda Civic

Posted by admin

This is a video showing how to reset the service reminder, or maintenance light on any 2006-2011 Honda Civic including Si’s. All you really have to do is hold the SEL/RESET button for 10 secods until the tachometer starts to blink, release it after it blinks for a few seconds, and then hold it for 5 seconds again until it changes the screen. Then your reset light is reset for another 5000 Miles. Please Comment Rate & Subscribe 🙂

Duration : 0:1:7

Read the rest of this entry »

Oct
22

2012 Mazda 6 airbag/seatbelt light flashing?

Posted by admin

I recently purchased a used 2010 Mazda 6. Today I noticed that the Airbag/seatbelt light started flashing on and off. What is it? How did I do it?

Well, you have a warranty. Take it in. No one on here can tell you what is wrong. Just take it to a Mazda Dealership.

The light may mean there’s an issue with the airbag so take it in!

Mazda Salesperson

Oct
21

vehicle airbag problem and diagnose

Posted by admin

My YouTube Channel: http://www.youtube.com/user/Thilakprince

Duration : 0:3:38

Read the rest of this entry »

Easy AdSense by Unreal